![]() Because this is your first boot it may take upwards to 10min for it to boot completely and allow you to set up the android system. Once this is complete, you will begin to boot into LineageOS. Once in Hekate, navigate too "Switchroot Android" again and select it without holding "Volume up". Now enter RCM mode and boot into Hekate again Otherwise go back to the Main Menu, select reboot, and tap the "Power off button" If you're not asked to install TWRP you will need to do so manually if you want root access on your device. However this time you will not need to hold "Volume-up" unless you want to access the TWRP menu again. Otherwise, go ahead and reboot your system into Hekate and select "Switchroot Android" like before. If you are asked to do so, go ahead and install it, and wipe the cache/dalvik. Once you go back to the main menu, you may be asked to install TWRP. Or install the "shield-ify" zip if you choose to use it. Once complete you can go ahead and click the back button to both leave the installation screen for the next step. You will also be asked to wipe the cache/dalvik after installation. If the system asks you to swipe prior to installation. Please select these zip files one at a time starting with "open_gapps" and install each of them. Now select install, and navigate up a lever in the folder selection on the page, then scroll down and select "external_SD"įrom here you will see your two ZIP files from the previous selection. If this step is not done you will be unable to install Open GAPPS Once the box is selected tap the back button. ![]() Swipe right to allow TWRP to make it's modificationsįrom here select Mount by touching it on the touchscreen, and check the checkbox next too "system" it may take a few seconds for any paritions to appear. Once in TWRP you will receive a message asking you to allow TWRP to keep the system as read only or not. Otherwise, you may not be able to complete the setup. You may need to reset up your SD Card as GAPPs need to be installed prior to first boot since this is a Beta release. Once you see this you can let go of "volume up" Please note, that if you do not enter this TWRP menu first. Do this and wait until you see the TWRP menu. Then scroll and select "More Configs."īefore you scroll and select "Switchroot Android" on this screen, get ready to hold your "volume up" button as you will need to press and hold this, the same time that you select "Switchroot Android" Once you're ready. Select Launch by scrolling with the volume buttons, and selecting it by pressing the power button. Once Hekate launches on your Nintendo Switch. From here you will now need to access RCM mode and push the Hekate payload. If you have not already, please take your SD card out of your PC and insert it into your Nintendo Switch. Now that the most difficult part of the process is complete, we can now learn how to both boot into our new Android installation, but what we need to do to set it up before it will work properly! To learn how to go about this, please check out this page ![]() To learn about RCM mode, how to access it please check out this page here.Ī way to push the hekate payload.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |